Have you ever wonder what is the difference between the Rockwell hardness tester, Vickers hardness tester, and Brinell hardness tester?

Well in the next 4 minutes, I will tell you everything you need to know of how to choose the right hardness tester for you!

The ability of any certain object or substance to resist indentation when a force is applied to it is known as hardness.

An object’s hardness should be classified as a feature or a characteristic rather than one of its properties and the hardness is generally measured by calculating the permanent area of the indentation caused by a fixed load.

The Hardwell and Brinell tests are two specific methods to measure hardness.

Teste Rockwell

The Rockwell Test is the easier of the two methods and tends to be more accurate. It can be utilized for testing metals of all sorts including hard metals (unlike Brinell Tests), except for circumstances where external factors play a part in preventing it.

Testador de dureza Surface Rockwell & Vickers

It also happens to be the most commonly used test.

The Rockwell Test uses specific steps to measure hardness.

Unlike the Brinell Test, it uses a smaller indenter such as a diamond.

This indenter is used to apply a minor load (Increased load/force is applied later) so as to avoid breaking the surface of the material.

This way it proves to be a less destructive method in comparison to the Teste Brinell.

Vickers Test

The Vickers test is ideal for test materials that do not require much load/force but rather increased accuracy during the testing procedure.

8-4500HK Torre Automática de Display Digital Vickers & Knoop (Double Indenter) Testador de Dureza

Equipped with the sharp point of its diamond indenter, the Vickers test also makes use of an optical system that enables magnification of the material’s target area.

This magnification ability allows the tester to focus on microelements on the surface and thus, be more accurate. This is vastly different from the other tests.

However, compared to the Brinell and Rockwell Tests, the Vickers Test is more expensive due to the preparation required and the cost of obtaining the optical system.

The testing procedure also takes more time than the Rockwell Test.

Teste Brinell

The Brinell Hardness Test method happens to be the very first test that was used widely.

Indutor digital Shore ACD TH-200 Tipo Dureza Indentador 20 ~ 90HA

It is usually used to measure the hardness of metallic materials with a specific preference given to materials that are rough.

It also may be the case that the material is simply unsuitable to go through other tests, thus leaving the Brinell test as the sole method of determining hardness.

The Brinell test, however, is not suitable for materials that have hardened too much with hardened steel being one of the obvious examples.

Testador de dureza Leeb Richter de display digital 17,9-69,5HRC, 19-651HB, 80-1042HV, 30,6-102,6HS

In addition to that, this method also happens to be quite slow in comparison to other tests and tends to make irreparable imprints on the metallic object or material.

So, If you are looking to buy a cheap hardness tester, please visit our site testhardness.com

We are a very professional hardness tester factory from China.

Espalhar o amor

Confira nosso testador de dureza de venda quente!